View Full Version : Group Buy

12-01-2008, 12:48 PM
Starting Janurary, details will be givin then.

Group buy on

FD engine Dampers
FD Trailing arms and toelinks

In March I will have a group buy on the FD v-mount after the revision of the brackets and ducting is complete. This kit is being revised due to driver feedback from drift drivers and also it is being updated to support race-spec time attack cars.

I am working with Falken signed driver Calvin Wan and refreshing his FD with the new set-up. The new set-up will be robust and will not interfere with the tow hooks which are used on drift and time attck cars. The new kit will include ducting. The kit will be a complete bolt on affair and will still allow you to keep A/C with the exception of the A/C lines which still require minor modification if you wish to keep your A/C.

Thank you,
Ben-Rotary Extreme

02-02-2009, 03:25 PM

Does anybody have any request on group buys or any questions about what's up and comming?


02-02-2009, 04:02 PM
I need toelinks and pillow balls...

02-02-2009, 06:50 PM
HDP, pm sent

02-04-2009, 05:02 PM
anything about the old RE Headlights?

02-05-2009, 11:59 PM
How about the Feed style side skirts. Can't find them anywhere in carbon fiber except the authentic ones and they are $$$$$$.

02-06-2009, 03:08 AM
I'm a little late on the aero kit section but it is going to re-open. As for the lights, I am getting everything to make them again but I'm also looking into the lexan cover to see if it is cost effective to have it shaped with the same contour as the pop-up cover. Otherwise it will remain a flat piece.


02-06-2009, 09:03 AM
that would be really cool if it followed the same lines.

04-06-2009, 09:12 AM
oil cooler setup for fd?

04-06-2009, 11:49 AM
RIZZXX7 pm'd

04-07-2009, 12:50 AM
how goes things with the vmount? :)

04-07-2009, 01:45 AM
half way there on the new design...almost done

04-15-2009, 02:13 PM
how about the headlights?

04-16-2009, 12:18 PM
I have located everything to re-make it. But I need to put one togther on my own first before I re-release it to make sure it has everything. Also it will be the same as before. You will have to pr-heat the lexan to get it to form to the housing, That way it matches the lines. This is something that I am thinking of doing so that the customers do not have to.