View Full Version : Red silicone sealant removal?
impulsive-RX7
10-22-2008, 12:42 PM
The previous owner of an engine sealed all the intake manifold gaskets with some kind of red silicone sealant. This shit is like glue. I need to remove the manifold but I can't get it to move at all.
Suggestions?
Whizbang
10-22-2008, 01:07 PM
heat
djmtsu
10-22-2008, 01:57 PM
Gasket remover and a scraper. You can also wire wheel it off.
SpooledupRacing
10-22-2008, 02:45 PM
By reading this it sounds like u cant get the manifold off of the engine..
get a hammer and tap the intake off the engine..
otherwise spray the edge down with
"goo gone" or brake cleaner
and that should soften it enough that a hammer will get it off
RotaryXperiment
10-22-2008, 02:52 PM
a rubber mellet, dont use household hammers! :rofl:
SpooledupRacing
10-22-2008, 02:54 PM
hell I use a 5lb sledge ... but yes a rubber mallet would be safer
RotaryXperiment
10-23-2008, 08:47 PM
haha and look at the smoke show u made in ur bushings lol
"no mercy on u. u, u , u stupid rubber!"
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.