WTB: 94+ Map Pocket with or without lid (black interior)

[RE_guru]

Looking for a 94+ Map pocket insert for the door I do not need it to have a good lid as I have that, but do need it to have intact lid pivot point.

The 1st picture below is the broken lid pivot I have and the 2nd picture is what it should look like.

https://i278.photobucket.com/albums/kk89/fddrifter44/20180917_222541_96b24c06a8407089b5ca367730c5a6079f e33eb7_zps1cgdlq9b.jpg
https://i278.photobucket.com/albums/kk89/fddrifter44/20180917_232203_0c619ef74efbbcec8a5c266df4d9ee1bbe cdf75e_zpsboaoqsgq.jpg

[speedjunkie]

I think I used a small allen head bolt on mine, just screwed it from the inside of the lid.

If that's your only problem with it, count yourself lucky lol. Those things are extremely hard to find in good shape and for cheaper than body parts or vital organs.

[RE_guru]

I have noticed. I am going to try and fix it for now but would like to get an unbroken one and see if i can 3d print them. I managed to find one on rx-7club but didn't respond fast enough and it was gone.

Do you remember what size allen bolt you used?

[speedjunkie]

I'd love it if someone printed all the interior plastics lol.

I don't remember for sure, but I'd guess maybe an M4 or M5. At one point I used a little plastic bushing from ACE hardware, but it's been so long I don't know if that's on the current setup lol.

[RE_guru]

I'd love it if someone printed all the interior plastics lol.

I don't remember for sure, but I'd guess maybe an M4 or M5. At one point I used a little plastic bushing from ACE hardware, but it's been so long I don't know if that's on the current setup lol.

I am currently working on the shifter panel light and switch mounts and will post up info when I get a prototype out. After that I was might try the dash end caps as I have broken mounting tabs on mine.

[speedjunkie]

Awesome! Can't wait to see them.

Oh you're in StL. I grew up in Southern Illinois not far from Belleville and I lived in Cape Girardeau 1990-96. Go Cards!