Harness Pics

[C. Ludwig]

We finally invested in a new label printer that prints on heat shrink. Allows us to make a better looking label than what we had been doing. This harness was built for a forum member for his FC. Sport 1000 harness setup for ID injectors, Hall effect crank trigger, and IGN-1A coils.


http://72.29.74.111/~lmsefico/wordpress//haltech/harness.JPG

http://72.29.74.111/~lmsefico/wordpress//haltech/label.JPG

[RXTASY]

That looks purty!

[Dannobre]

Lot easier than printing them on little bits of paper and cutting them out ;)