Need some help getting Rx2 metal...

[sen2two]

I have been emailing, calling, and looking everywhere all over the country for someone willing to cut up there junk Rx2 to get some metal to fix my 72 coupe. I have found a few people who say they will, and then never come through.

So I'm asking now. This is what I need. Pics and descriptions below...

So if you know someone or somewhere I can get this from, PM me asap or send them a link to this thread. This would be greatly appreciated. And would bring another Rx2 back to life!!!


This is needed so i can weld in my new frame rails. I do not believe the metal there is strong enough for me to weld in good clean new metal. So i would like to replace it with un-rusted metal. What I need is inside the red lines below. I do not need it to be in one piece. What I mainly need is there area half way up the fire wall down to the seat bracket area. I need each side. I really don't need the trans tunnel. There must be ZERO rust on the metal. I'm located in Kissimee, Florida.



http://i282.photobucket.com/albums/kk253/bboynero/1972%20Rx2/SAM_0463.jpg







I will also need both rear quarter panels and the lower rocker from front to rear on the passenger side. A clean set of front fenders would be nice also. Put the word out!!!

[fire85gslse]

the floor area is rusted on my 73 4 door. Might have good fenders, as for rockers show me a pic and I will see what she has.

[capellarx]

the floor area is rusted on my 73 4 door. Might have good fenders, as for rockers show me a pic and I will see what she has.

thanks for making me wait for the rx2 dash after calling you from australia so many times and you telling me you were going to call me when you get it out. I let a few go waiting for you and then i later found out you sold it on ebay.:patriot:

[fire85gslse]

thanks for making me wait for the rx2 dash after calling you from australia so many times and you telling me you were going to call me when you get it out. I let a few go waiting for you and then i later found out you sold it on ebay.:patriot:

You might want to get your facts straight before you post info on here and trying to make me look like an ass. I sold my 2 door mint car (never intended to part it) and still have the 4 door parts car sitting in my drive way! Wont be pulling anything for you now though..... hope your happy you screwed yourself.