ITBs

[project86]

Does anyone know if anyone besides tweakit.net makes itbs for the 20b? id like to see something that incloses the injectors with the filter instead of exposing them.

[djmtsu]

Took 5 seconds.

http://www.tweakit.net/shop/product_info.php?cPath=57_49_32&products_id=118

You're welcome.

[project86]

Does anyone know if anyone besides tweakit.net

Took 5 seconds.

http://www.tweakit.net/shop/product_info.php?cPath=57_49_32&products_id=118

You're welcome.

thanks anyway :) i know about the tweakit ones. i just didnt see a filter set up for the 20b. i know they sell one for the 13 itbs. i just dont really like the idea of the open area between the injector and the bell with no filter.

[FerociousP]

thanks anyway :) i know about the tweakit ones. i just didnt see a filter set up for the 20b. i know they sell one for the 13 itbs. i just dont really like the idea of the open area between the injector and the bell with no filter.

Took 5 seconds.

http://www.tweakit.net/shop/product_info.php?cPath=57_49_32&products_id=118

You're welcome.

can I do it?....


....PWND....


You're welcome.


On topic: I do not know of any setups at this time.

[project86]

haha thanks. i just thought id put a thread out there. i have seen a vid on youtube of a guy that has what im lookin for.. he probly made it custom though.

[Whizbang]

efi hardware might have something

[project86]

thats perfect man! thanks much!

[aaron_bc]

Is there any company that makes a manifold for ITBs for a side port 20b? No going PP.

It's either find something bolt on, or run the 20b intake with a ported throttle body to keep things simple and cheap.

[project86]

i would check out a single 90mm TB to start with. it will save you some coin and should be a good middle ground to the stock TB and ITBS. I believe RotaryWorks sells one.

[aaron_bc]

I may just get the LIM/UIM extrude honed and run a ported 20b throttle body.