- Whats the difference?
- Mazdatrix Titanium Rotors
- Multiple Ports on One Housing
- my 84 se start problems
- Pro jay manifolds
- use of BJ89 as a parts cleaner?
- Itb's and runner length
- Run Pre-mix or run RA OMP?
- What year engine?
- BP, the yays, the drawbacks, the limitations and reliability
- High powered setups dying of old age
- Conservative Limits for Injectorants
- E&j throttle body NON turbo
- 3 window bearings
- injector question
- Misc Aquamist docs and info
- engine issue
- Trying to learn how to read compressor maps
- Exhaust Flow: Volume verses Velocity
- Exhaust manifold design
- Dyno?
- Mazdaspeed Motorsports Program?
- Main pulley bolt washer question
- Renesis seal wear specs
- 13B Power @ 1 bar absolute pressure, to see what you might have if you MAN UP!
- Measuring PP port timing
- Rotary Turbos and Turbo bags!
- S4 engine with S5 housings
- Intake questions for 12a bp...
- EGT: how high does it need to log
- Improvements to the Rotary?
- New NGK BUR7EQ / BUR9EQ Spark Plugs
- Spark plugs
- SACHS Rotary engine revival
- 4 port or 6 port
- tech question on Leading spark plug hole location
- AEM Failsafe
- what aftermarket apex seal would you choose?
- Housing tolerance
- Apexi PFC Intermediate Weak or No Spark
- Custom exhaust advice
- large metal pieces in oil pan?
- Problems after changing fuel setup.
- What does the rotary motor look like.
- what 4 port irons are these?
- Rules of Conduct -by Phoenix7
- Cleaning out oil cooler after bearing failure?
- ever see this before? center iron failure
- Rotary Engine / Parts Identification Guide
- Is this housing good?
- mixing oem engine bolts and aftermarket stud kit
- Engine Wiring 101
- looking for water/meth injection tips
- Should I use or loose this iron?
- Blown to pieces literally
- EFR Internal Waste-Gate Discussion
- Oil Pedestal Adapter...
- Sacrificial Anode
- two cycle oil
- Painting heat exchangers
- Testing CAS signalI just finii
- Let's talk turbos.
- Just tore my T2 motor down need opinions pics inside
- Replacing tension bolt seals of assembled engine
- Evap/Emissions System Question
- Turbo gasket failure.... bye bye BDC, and HC pardigm shift right here LOL
- Coil relay?
- Custom Exhaust Question
- need help to price old 13 B and trans
- Direct Compressor Injection? Water/Meth
- Rotor Side Clearance
- Side seal springs & Oil Control ring springs questions
- Semi p-port: Does size matter?
- Zero clearance side seals round 2. (If you don't mind Barry)
- Ray Crowe "help" email scam
- Oil Control O-Rings - which are better?
- Storing Rebuilt Engine
- Did Mazda change something or...
- question about rotor gears
- My thoughts on a Bridge-Port 13b :)
- 13b series 4 engine non turbo questions?
- Rotary VS VVTurbo... Is my theory unrealistic?
- New Rotary Engine Sports Car
- Exhaust
- Coolant leak around engine studs?