04 6MT Blown ECU???

mecjacob · 06-15-2009, 06:01 PM

Thats kinda what I thought. Although it is pretty easy to install it correctly unless it is just not a compatible sensor. But my big concern is that after I removed the new sensor and just plugged it back up it still runs like it did after I installed the new sensor, horrible. And Im not even getting 5v to the sensor plug on top of the bell housing, only about 2.5. So is it possible that putting in a non compatible sensor ruined my ECM?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-15-2009, 06:01 PM	#3
mecjacob The Newbie Join Date: Jun 2009 Posts: 3 Rep Power: 0	Thats kinda what I thought. Although it is pretty easy to install it correctly unless it is just not a compatible sensor. But my big concern is that after I removed the new sensor and just plugged it back up it still runs like it did after I installed the new sensor, horrible. And Im not even getting 5v to the sensor plug on top of the bell housing, only about 2.5. So is it possible that putting in a non compatible sensor ruined my ECM?