Quote:
Originally Posted by Fidelity101
Okay I just got done putting a motor and trans back into the car and have everything wired up ready to go and as soon as I hook the battery up you hear the starter freewheeling.
|
I have an idea on this, however, is the starter "free spinning" without engaging the flywheel (not turning the engine) or does the engine spin?
Quote:
Originally Posted by Fidelity101
I have the battery + to the starter and that same connector goes to B+ on the alternator, then that other starter cable from the harness is on the other solenoid terminal that has that small wire that goes from the starter to the starter solenoid.
|
if I understand this correctly, you should not have a direct path from the top "B" terminal to the "S" terminal, ever.
The small terminal on the side of the starter solenoid should be a 12 volt ignition (start pos.) switched power.
Quote:
Originally Posted by Fidelity101
the signal wire is hooked up too
I was getting low resistance between the battery positive and negative connectors (not terminals)
|
What????? 
please explain this.
-Pat
__________________
That to secure these rights, Governments are instituted among Men, deriving their just powers from the consent of the governed, — That whenever any Form of Government becomes destructive of these ends, it is the Right of the People to alter or to abolish it, and to institute new Government
-The United Stated Declaration of Independence
|
04-20-2009, 02:00 PM
Threaded Mode