resurface and harden/heat treat the irons what your take on this?

proz07 · 02-22-2009, 03:21 PM

its for the side plates front, middle, rear. the rotor housings get something diferent usually refered to ceremet coating. but the regrind and renitriting is for plates that are out of spec and you just dont want new or good used ones. such as the 12a's that are nolonger being made.

Good process to do? only if you need it because your plates are out of spec.

im sure others can comment on prices iv never done it to be able to tell you if its even a financial option.

z

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-22-2009, 03:21 PM	#2
proz07 Needing a new tow rig. Join Date: Mar 2008 Location: AR Posts: 245 Rep Power: 18	its for the side plates front, middle, rear. the rotor housings get something diferent usually refered to ceremet coating. but the regrind and renitriting is for plates that are out of spec and you just dont want new or good used ones. such as the 12a's that are nolonger being made. Good process to do? only if you need it because your plates are out of spec. im sure others can comment on prices iv never done it to be able to tell you if its even a financial option. z