Rotorhead87's Cosmo 13B-RE FC3S build-up

rotorhead87 · 01-30-2009, 04:51 AM

Okay not much too update on I been really busy with full time college. I been working on the elbow/intercooler pipe. Anyways I'm using an FD's throttle body which has 4 mount points. We decided to use the original 13B-RE's aluminum elbow, but it has 3 mounting points. Anyways JR Fab & Per welded an adapter so that the elbow would fit. At the same time I had the thicker parts of the pipe ground down to reduce any turbulance inside. I been working on it here and there, still needing some work

. So here's my progress so far.

You can go to post #102 to use as a "before" picture of the elbow/piping

01-30-2009, 04:51 AM	#21
rotorhead87 Rotors > Pistons Join Date: Sep 2008 Location: Port Saint Lucie, Florida Posts: 316 Rep Power: 18	Okay not much too update on I been really busy with full time college. I been working on the elbow/intercooler pipe. Anyways I'm using an FD's throttle body which has 4 mount points. We decided to use the original 13B-RE's aluminum elbow, but it has 3 mounting points. Anyways JR Fab & Per welded an adapter so that the elbow would fit. At the same time I had the thicker parts of the pipe ground down to reduce any turbulance inside. I been working on it here and there, still needing some work . So here's my progress so far. You can go to post #102 to use as a "before" picture of the elbow/piping __________________ *UPDATED 06/15/2009* Check out My VMIC Turbo 13B-RE FC3S build Last edited by rotorhead87; 01-30-2009 at 05:16 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode