|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
| View Poll Results: Do you adjust your gaskets? | |||
| Yes |
   
|
4 | 66.67% |
| No |
  
|
0 | 0% |
| Yes, but only if they are far off. |
  
|
2 | 33.33% |
| No, I never noticed/thought that they can be off. |
  
|
0 | 0% |
| Voters: 6. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
10-21-2008, 07:10 AM
|
#4 |
|
Guest
Posts: n/a
|
I voted yes but let me expalin...
I rarely ever have noticed a gasket that was off, the only time I have to is when I port stuff then I will either gasket match the surface OR match the gasket to the port.. IMO that gasket is a failure. Try again or buy better quality gaskets maybe.. |
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode