Stredrotor's RX4 Coupe * Project 20B *

Stredrotor · 08-31-2013, 04:52 AM

Started work on the sump as the custom one that come with the motor won't fit.

I had the flange cut then started working on how much room I have.

I removed the old front engine mount cross member as I need a bit more clearance.

Then I mocked up the lower half in cardboard.

Next to the old custom sump.

After that I modelled it up in Inventor.

Even welded it!

Should give me a bit over 5 litres capacity.

Now I just need get the lower half cut.

08-31-2013, 04:52 AM	#31
Stredrotor Rotary Fan in Training Join Date: Nov 2009 Location: Tasmania, Australia Posts: 53 Rep Power: 17	Started work on the sump as the custom one that come with the motor won't fit. I had the flange cut then started working on how much room I have. I removed the old front engine mount cross member as I need a bit more clearance. Then I mocked up the lower half in cardboard. Next to the old custom sump. After that I modelled it up in Inventor. Even welded it! Should give me a bit over 5 litres capacity. Now I just need get the lower half cut. __________________ RX4 coupe 20B conversion http://www.rotarycarclub.com/rotary_...ead.php?t=9884

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode