Is this rotor usable?

JustJeff · 11-20-2010, 12:38 AM

^TTT

My concern regarding the clearance is the difference between the top where the damage is and the bottom where it's same measurement as my good grooves. I don't want to pay shipping back to the seller and have him tell me it's in spec because the bottom of the groove is in spec.

I'm not wanting to go 3mm. I don't live near any rotary shops or machine shops that have any experience with "das wankel" That means shipping two rotors out and back..along with labor costs for milling.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-20-2010, 12:38 AM	#1
JustJeff RCC Contributor Join Date: Mar 2008 Posts: 505 Rep Power: 18	^TTT My concern regarding the clearance is the difference between the top where the damage is and the bottom where it's same measurement as my good grooves. I don't want to pay shipping back to the seller and have him tell me it's in spec because the bottom of the groove is in spec. I'm not wanting to go 3mm. I don't live near any rotary shops or machine shops that have any experience with "das wankel" That means shipping two rotors out and back..along with labor costs for milling.