View Single Post
Old 11-15-2017, 02:12 PM   #8
Lifetime Rotorhead
Pete_89T2's Avatar
Join Date: Apr 2010
Location: Elkton, MD
iTrader: (1)
Posts: 868
Rep Power: 9
Pete_89T2 is on a distinguished road

Originally Posted by project86 View Post
Pete I'm interested in the Oil Temp and Water Temp gauges. I need to check to see if they will match my OP gauge first though. I can't remember which one I bought. Where you using the temp sensor that you have to cut the radiator hose up?
The temp sensors are 1/8'NPT. When I was using these gauges, I installed the water temp sensor installed in a brass "T" fitting that I spliced with hose barbs into that 3/8" water hose that runs between the BAC & WP housing.

Alternatively, some FCs have an unused spot on the back of the WP housing where you can drill & tap for the 1/8"NPT sensor.

BTW, here's a link to the Prosport site for the same series gauges I'm selling so you can compare to your existing oil pressure gauge -

Last edited by Pete_89T2; 11-15-2017 at 05:57 PM.. Reason: Added link
Pete_89T2 is offline   Reply With Quote