View Single Post
Old 11-15-2015, 06:31 PM   #41
Lifetime Rotorhead
Pete_89T2's Avatar
Join Date: Apr 2010
Location: Elkton, MD
iTrader: (1)
Posts: 864
Rep Power: 9
Pete_89T2 is on a distinguished road

Calling this "fabrication" is a bit of a stretch, but if anyone is building up a rotary and is lacking the spendy tool needed to measure step wear on the plates, this little bracket thingy I made and a standard dial indicator will do the job rather well. All this is is a chunk of solid AL bar stock and an AL right angle piece bolted to it, that I bolted the dial indicator to. Pictures describe it better than words...

Attached Images
File Type: jpg 100_1282.jpg (101.8 KB, 88 views)
File Type: jpg 100_1284.jpg (109.0 KB, 88 views)
Pete_89T2 is offline   Reply With Quote