View Single Post
Old 04-16-2018, 01:24 PM   #209
infernosg's Avatar
Join Date: Dec 2009
Location: Richmond, VA
iTrader: (5)
Posts: 811
Rep Power: 10
infernosg is on a distinguished road

Originally Posted by djmtsu View Post
Interesting. I personally have only ever had ONE wheel bearing go bad on an FC, and I blame Chicago for that (when I lived there).

It isn't common, but I suppose it does happen. I have a couple of loaded knuckles. But they are quite heavy.
I didn't notice anything until I took the car in for an alignment a while back. They mentioned some play in the wheels so I took a look. Both sides had some play at that time but after resetting the pre-load per the FSM the passenger side was fixed. I think this just confirms the bearings were okay but something else is going on. The spindle looked okay but I didn't see any movement in the ball joint in the lower control arm so I don't know what else it would be. It seems unlikely I have two sets of bad bearings.
infernosg is offline   Reply With Quote