View Single Post
Old 04-16-2018, 12:08 PM   #207
infernosg
IT'S ALIVE!
 
infernosg's Avatar
 
Join Date: Dec 2009
Location: Richmond, VA
iTrader: (5)
Posts: 811
Rep Power: 9
infernosg is on a distinguished road
Default

Replaced the front wheel bearings and races yesterday since I had play in the driver's side. I heated the hubs in the oven and rapidly cooled the outer races with ice water get them out. I ended up re-using the seals though. The new seals put too much pressure on the hub to get an accurate measurement of the bearing pre-load (followed FSM procedure). Unfortunately, I'm still getting play on the driver's side. I'd go as far as saying it isn't improved. I even went out today and torque the hub nut to 22 ft-lb and STILL had play. I didn't see anything else moving so I'm left with the assumption the spindle itself is worn out. Does that even happen on these cars? I guess I'll try to find a used one and replace it before DGRR.
infernosg is offline   Reply With Quote